Firmware stock ROM (flash file) this Firmware can be use to Flash Unbrick or Upgrade Tecno W5 Lte
Take a Backup of your personal data before flashing or installing the firmware on your smartphone.
As this helps you to recover the personal data whenever any thing wrong happen.
SEE TECNO W5 Lite QUICK SPECS BELOW.
Dimension: 153.2 X 76.4 X 7.8 mm.
Android 6.0 Marshmallow.
Mediatek Chipset. MediaTek 6737
RAM: 1GB
Internal Storage Memory: 16GB.
SD card Slot: Yes, support up to 64GB
Rear/Back Camera: 13 MP autofocus camera f/2.0 Up-to (3264 x 2448 pixels)
Front Facing Camera: 5MP
Video Recording: YES
Flash: Yes (LED Flash)
Finger Print,
Battery Capacity- 3000mAh Non-Removable Battery.
Fast Charging Support: Yes
Standby Time: over n/a
HOW TO FLASH Tecno W5 Lte?
The below tutorial only works with the Stock firmware or Custom
Rom which comes with the Scatter file in it (basically Mediatek
devices).
Take a backup of your important data before using the Smart Phone Flash Tool as because during the flashing process your personal data will be removed permanently.
Your Android Smartphone should have at-least 40-50 percent of battery to perform the Flashing Process.
Take a backup of your important data before using the Smart Phone Flash Tool as because during the flashing process your personal data will be removed permanently.
Your Android Smartphone should have at-least 40-50 percent of battery to perform the Flashing Process.
Download and extract the stock firmware on your computer.
Install the USB Drivers (skip if drivers are already installed).
Open the SP Flash Tool and load the Scatter File from the firmware folder.
Connect your Smartphone to the computer using the USB Driver.
Click on Upgrade / Download Button in the SP Flash Tool to Begin the Flashing.
Green Ring will appear at the end of successful Flash.
Congratulations, Now your Android Smartphone is successfully running the Stock Rom you have Downloaded.
You Can Also Flash This Device Using SPMultiPortFlashDownloadProject
Turn off the smartphone. Cable is not connected to the computer.
Remove the battery and insert it again
Connect your phone to a computer cable. The operating system detects a new device
Disconnect the cable from the computer.
Run SPMultiPortFlashDownloadProject.exe
Choose File> Open File Agent download and specify the file MTK_AllInOneDA.bin (it is in the folder SP_MDT).
Click "Start all".
Connect your phone to a computer cable. The program should see and blink. If the phone is not detected, then unplug it from the computer,
remove and insert the battery (if the battery is removable) and reconnect it to the computer.
After (OK) click Stop and disable any phone.
Completed.
- Tecno W5 Lte STOCK ROM
- W5Lite-H8010A1-M-161014V147
 this Firmware can be use to Flash Unbrick or Upgrade...){kind=link}
0 comments:
Post a Comment